Small-Pitch Knife-Edge Range
The small-pitch range covers knife-edge conveying in pitches from 5 mm to 19 mm. Its official product page lists the styles as Flat Top, Flush Grid, Raised Rib, Perforated Flat Top, Friction Top, and Insert Roller, and lists the configurations as Straight Running and Side Flexing. The page describes modular construction with lighter weight materials, and describes the range as easier to install, repair, clean, and maintain, increasing throughput while minimizing downtime. Those descriptions are product-page wording, not measured values.
One caution about the source: the extracted product-page text was truncated mid-sentence at the side-flexing description, so wording beyond that point is not recorded here and is not paraphrased. Do not treat this page as a complete account of the side-flexing configuration.
Recorded figures
- Pitch range: 5 mm to 19 mm
- Styles listed: Flat Top, Flush Grid, Raised Rib, Perforated Flat Top, Friction Top, Insert Roller
- Configurations listed: Straight Running, Side Flexing
- Construction described: modular, with lighter weight materials (product-page wording)
These are the only figures recorded for this series in the source material. No further figures are published for this series on this site; ask the supplier to confirm any other figure for the exact series before ordering.
What knife-edge conveying asks of an inquiry
Knife-edge conveying moves product over a small end roller or edge, so the transfer matters more than the belt name: what the product is, how it must leave the belt, and what gap it must cross. Put the product and the transfer into the inquiry, and ask the supplier to confirm which style and pitch in this range suits that transfer.
Because the range spans 5 mm to 19 mm across six styles, do not order by the range name alone. Ask for the exact style and pitch offered for your transfer, and for the figure behind any throughput or lifetime description, in writing.
What is not recorded
No per-style pitch table, no belt width, no load figure, no speed figure, and no material assignment is recorded for this range. The side-flexing description beyond the truncation point is not recorded either. Ask the supplier to confirm each one for the exact style and pitch in writing.
What to confirm before ordering
- Ask which style and pitch in this range suits your transfer, and why.
- Ask for the figure behind any throughput or lifetime description, in writing.
- Ask what material is recommended for your operating temperature.