Straight Running Belts
Straight running belts are one of the four navigation families on the official site, for conveyor runs that travel in a straight line rather than turning. No per-model specifications are recorded for this family in the source material, so this page carries no figures: it orients you toward the detail pages that do.
The detail pages in this family area are the HS-100 and HS-100-N series, each with a recorded pitch of 50.8 mm, and the small-pitch knife-edge range, which lists Straight Running among its configurations. A straight run still needs its own questions answered — width, load, material, and transfer — and those answers belong to the exact model, not to the family name.
How to use this family page
Start from the detail pages for recorded figures, then use the questions below for anything the detail pages do not record. If your run is straight but your product needs a grid surface, look at the open grid and flush grid detail pages instead, and ask the supplier which surface suits your product.
What is not claimed here
No width, load, speed, or material figure is claimed for straight running belts as a family, because none is recorded. No capability is claimed for any industry on this page. Certificates available upon request.
What to confirm before ordering
- Ask for the belt width offered for your run, and the exact model it applies to.
- Ask for the load figure that applies to your line, with the document behind it.
- Ask what material is recommended for your operating temperature.